Move pointer over the image to zoom in

Chroma Servo Board
V3 for Raspberry Pi
Rp.250,000
Qty:

Chroma Servo Board for Raspberry Pi is a small board that connects to a Raspberry Pi and allows you to control up to eight RC servos (or ESCs) via the serialport in the GPIO port of the Raspberry Pi. The commands for the serial version are simple ASCII. The 2x13 pin header on top is a pass through if you want to connect other cards using the GPIO-port. Of course this SW will also be open source. The serial ASCII protocol will be  The output is buffred and made 5V by a buffer IC.

The card also has a 8 pin connector (unmounted) that exposes 6 GPIO-pins of the ATmega8 CPU, +3.3V and GND. With firmware version 0.2 there are experimental support to use them as as digital output controlled via a serial command. If you want to make your own firmware the pins is also the ATmega8s I2C lines (2 pins) and SPI (4 pins).

Features :
  1. Costumized For Raspberry Pi, Plug and Play
  2. Support up to 8 RC Servos or ESCs
  3. Support AVR-Programming MCU
  4. 8 Pin connector of The ATMega8 CPU
  5. Size: 39.6 mm x 35.7 mm x 18.5 mm
Detail :
via Iteadstudio
 
  • Availability: 5
  • Model: V3 for Raspberry Pi
  • Manufacturer: Iteadstudio
Powered By AbanteCart
TOKOMINIKOMPUTER.COM © 2017
Back to top