Sort By:  
  • Banana Pi M2+ case (Acrylic)
    Banana Pi M2+ case akrilik 6 sisi
    Add to Cart
  • Banana Pi M3 Case (Acrylic)
    Case untuk Banana Pi M3 bahan dari akrilik 6 sisi
    Out Of Stock
  • Webduino


    • WiFi Module – AI Thinker ESP-12F module with Espressif ESP8266 WiSoC
    • Connectivity – WiFi 802.11 b/g/n
    • 2x 8-pin headers with GPIOs,  ADC (Connected to Photocell), UART, VCC, 3.3V, GND, and Reset.
    • USB – 1x micro USB port for power
    • Misc – Photo resistor, RGB LED, micro switch button for firmware upgrade (connected to GPIO 4)
    • Dimensions – 3 x 2.5 cm
    Add to Cart
  • Banana Pi M3 (A83T ARM Cortex-A7 octa-core)
    CPU : A83T ARM Cortex-A7 octa-core,512 KB L1 cache 1 MB L2 cache
    GPU : PowerVR SGX544MP1· Comply with OpenGL ES 2.0, OpenCL 1.x, DX 9_3
    Memory : 2GB LPDDR3 (shared with GPU)
    Storage Support : MicroSD Card(up to 64GB)/SATA(up to 2TB USB-to-SATA; GL830)/eMMC(8GB onboard)
    Onboard Network : 10/100/1000Mbps ethernet (Realtek RTL8211E/D)
    WiFi : 802.11 b/g/n (AP6212)
    Bluetooth : BT4.0 (AP6212)
    Video In : Parallel 8-bit camera interface MIPI Camera serial Interface(CSI)
    Video Out : HDMI 1.4 DHCP 1.2 with resolutions from(640x640 to 1920x1080)
    MIPI DSI for RAW LCD panels
    Audio Out : 3.5 mm Jack and HDMI
    Audio In : On board microphone
    Power Source : Micro USB, optional 5V DC port (center positive 1,6 x 4,4mm)
    USB Ports : 2x USB 2.0, USB OTG(Micro USB)
    Buttons : Reset button, Power button, U-boot button
    GPIO : 40 Pins: GPIO, UART, I2C bus, I2S bus, SPI bus, PWN, +3.3v, +5v, ground
    LED : Power LED(red), RJ45 LED(blue), user define LED(green)
    OS : Android and Linux etc.OS
    Dimensions : 92mm x 60mm
    Weight : 45g
    Coming Soon
  • Banana PI M2+ (H3 Quad-core Cortex-A7)
    Features :
    • H3 Quad-core Cortex-A7 H.265/HEVC 4K
    • Mali400MP2 GPU @600MHz,Supports OpenGL ES 2.0
    • 1GB DDR3 (SDRAM shared with GPU)
    • MicroSD card (Max. 64GB), 8GB EMMC Flash
    • 10/100/1000 Ethernet RJ45 Realtek RTL8211E
    • WiFi b/g/n Ampak AP6212
    • CSI connector for 8-bit YUV42 CMOS sensor and capture of 1080p@30fps
    • HDMI + AUDIO
    • DC 5V @ 2A (4.0mm/1.7mm barrel plug - centre positive)
    • 2x USB 2.0
    • Power Button, Reset Button, Uboot Button
    • 3 pin UART, CSI, 40 pin GPIO
    • OS Android, Raspbian, Ubuntu, OpenSUSE, Debian, Bananian
    • 65mm * 65mm - 48g
    Add to Cart
Per Page      1 - 5 of 5
Powered By AbanteCart
Back to top